The 65 cm or 85 cm antenna dish of the Oyster® system provides TV and radio programmes throughout Europe, in Northern Africa and the Middle East. The innovative swivel-head technology ensures extremely reduced power consumption, lower space requirement and optimised mechanical load.
The centerpiece of the satellite antenna is the LNB, which bundles and processes the satellite signals. According to your individual needs , this high performance module is available in different variants. For example, if you want to use a second receiver, e.g. in the sleeper compartment. The TWIN-LNB allows two different programmes to be viewed using a second receiver.
For optimal reception at the limits of the reception ranges in South-Western and South-Eastern regions, the LNB may have to be rotated in order to compensate the polarisation deviation - or SKEW angle - caused by the earth’s curvature.
Simple Operation of your choice
The basic system can be operated via the connected control panel, the premium system allows you to easily control all devices via a single remote control.
With the ten Haaft® app, you can now also use your smartphone or tablet to operate the Command Unit of the Vision or Premium variants.
Dimensions Command Unit (B x H x T): 21,6 x 4 x 12,2 cm
The Command Unit houses all control electronics of the satellite system and is usually concealed in a cupboard.
Dimensions without mounting frame (W x H x D): 11,8 x 7,1 x 0,8 cm
Dimensions with mounting frame (W x H x D): 12 x 7,3 x 1,9 cm
The easy to use control panel should be located in a more accessible spot. A single button push raises the dish to the last reception point (LEM). If it doesn‘t receive a signal at this point, it begins a fully automatic search.
Connection cable kit (5 m)
The cable kit connects the satellite antenna to the control unit. It includes power cords for activating the system and a double-shielded satellite-capable HF cable. The cable kit can vary, depending on the model.
Mounting plate 50 x 37 cm
All ten Haaft antennas are installed on anodized aluminum mounting plates. As these mounting plates are bonded to the roof using a special adhesive, additional boltholes in the outer vehicle skin are not necessary. There are four studs on the mounting plate to where the system is fastened with four cap nuts. This makes it easy to remove the system from the roof for potential repair work – or when every inch in your garage or carport counts.
Operating- and mounting instructions
Of course we deliver our products always with the appropriate manual.Thus you can read all settings and operations in detail.
The mounting instructions contains detailed information about the installation of the satellite antenna.