| Energy at a glance

tHE Control Station

The tHE CS control unit can be connected to an inverter/charger combination and to a battery from the tHE BatPro series.
You can then use just one control unit to monitor your tHE BatPro series battery as well as the powerful inverters (INC/INV) or the battery charger (INC).

If you have several tHE Bat Pro series batteries connected in parallel in your vehicle, the TOTAL power or capacity of the connected batteries will be displayed.

Additional features

  • 2.8" colour RGB TFT display with capacitive touchscreen
  • One large central backlit control button
  • W2 RGB LED indicators for important operating statuses
  • 1 warning indicator
  • 1 modulatable audible signal generator

Display of important operating
parameters

  • Battery charge/discharge currents
  • AC output power
  • Display of power consumption from the mains supply and for all settings on the INC

Available settings

  • Load capacity of the mains supply (campsite fuse)
  • Settings for battery charging/discharging
  • Different profiles for LiFePO4 batteries (performance vs endurance)

Battery monitor for the Bat Pro series

  • Battery charge status display (SOC=StateOfCharge)
  • REAL charging or discharging current from the battery out/in display
  • Operating status display

undervoltage protection

  • Battery voltage shutdown from 11.8V to 10.5V (default)

tHE Control Station

Power Saving

The power saving function can be configured via the tHE CS control panel so that the maximum permissible input current from the mains supply can be adjusted. If this value is exceeded, the tHE INC Inverter Charger first reduces the battery charge. If this is still not sufficient, a warning sounds and the tHE INC Inverter Charger switches off. The customer can then start the load, i.e. the current consumption, via the tHE INC Inverter Charger.

Capacity measurement (from the BMS)

When connecting a tHE INC inverter charger to a tHE Bat Pro battery, operation can also be terminated depending on the battery’s state of charge, as the battery can transmit the state of charge to the tHE CS control unit.

This means that discharging (i.e. inverter operation) can be switched off at any desired SOC (state of charge) and automatically restarted at any other, higher SOC. Or, even better, manual start-up is permitted again.

hibernation mode

Together with a battery from the tHE BatPro series, the tHE CS control unit can switch off the battery and put it into ‘hibernation mode’. This means that all devices are then disconnected from the power supply and the battery is prevented from discharging.

Hibernation mode is very easy to activate and can therefore replace the conventional ‘bone’ for completely switching off the living area.